This is an old revision of the document!
The Paired-plot Method is a technique for estimating utilization or destruction of plant biomass over time by the comparison of pairs of plots - one of the pair being subjected to grazing/foraging/use while the other one is not. The plots are set up before the use occurs and after the use has occurred, the vegetation in each plot is clipped and the vegetation weights compared. The differences in weights between the pairs are averaged over all plots to estimate the average utilization.
The Paired-plot Method is implemented as follows (please refer to the technical reference as it contains much more detailed instructions on implementing this method). First, a pre-determined number (ideally determined through analysis of the variability of some pilot sampling data) of locations of plot pairs are selected at random from within the sampling area. A cage is anchored over one plot of the pair (refer to the technical references for design considerations). The other plot of the pair is left open to foraging/use (again, consult the technical references for considerations in locating/marking open plots). Data collection consists of clipping and weighing current year's growth on key species from the protected and unprotected plots. Percent utilization per plot pair is calculated as the difference between total protected and unprotected weights divided by the total protected weight.
This method has several key advantages. First, it is a conceptually straightforward method and a direct measure of utilization. Second, the little training that is required to implement (aside from plant identification) this method can be given quickly, and this method is generally very accurate.
There are several disadvantages to consider as well: First, this method can be very time consuming and requires that the plot pairs be established beforehand. Also, results can be influenced by plot placement (e.g., protected plots placed in long-term exclosures may not be representative of ungrazed conditions outside of the exclosure), so careful consideration must be given to where plots are located. Second, new plots must be established every time sampling is conducted as once the sampling has been completed, the plots cannot be used again because all the vegetation has been removed. Third, the Paired-plot Method doesn't account for regrowth (and potential re-browsing) of forage plants (i.e., cumulative plant growth). This could be problematic when the time-span is long between when the plots are established and when the clipping takes place.
Related utilization and residue measurement methods include:
You must have an account and be logged in to post or reply to the discussion topics below. Click here to login or register for the site.